Stubai 282413 Eaves Bender
This bender is used to bend sheet metal over the drip edge in excess of 90 degrees to prepare for finishing under drip edge
When handle is pulled back, tool locks on metal to prevent slipping
1” bending depth
Jaw width: 9 3/4"
This tool bends clean without leaving any marks.
. It´s also possible to bend a flat-seamed standing seam around and underneath the drip edge.
This bender is used to bend sheet metal over the drip edge in excess of 90 degrees to prepare for finishing under drip edge
When handle is pulled back, tool locks on metal to prevent slipping
1” bending depth
Jaw width: 9 3/4"
This tool bends clean without leaving any marks.
. It´s also possible to bend a flat-seamed standing seam around and underneath the drip edge.
Write Your Own Review